FAQ

Store tools in dry and cool areas away from sunlight and rain. Place rubber accessories like suction cups and gaskets separately to avoid permanent deformation from long-time extrusion. Protect cutter wheels of cutting tools from collision and tooth breakage during storage. Empty residual glue inside caulking tools before storage. Store tools by category, check wear of vulnerable parts regularly and prepare spare replacement components in advance.

They are not interchangeable. The feeding structure of cement guns is designed for high-viscosity cement mortar and grout with strong pushing force. Regular caulking guns fit low-viscosity silicone glass adhesive with smaller push rod and outlet size. Mixing them will cause stuck output, damaged push rods and unsmooth glue extrusion.

It is mainly used for cutting round and curved glass with freely adjustable cutting radius, suitable for round table glass, circular decorative mirrors and curved craft glass. It cannot cut straight panels, and handheld cutters or push cutters are still required for large straight cutting work.

First, aging, cracked or dust-stained sealing gaskets break the seal. Second, wet, oily or uneven panel surfaces for adsorption. Third, worn vacuum valves inside the suction cup cause air leakage. Fourth, long-term sun exposure accelerates aging of rubber parts. Suction can be recovered by replacing gaskets, cleaning panel surfaces, inspecting valves and storing tools in cool areas.

Standard dust blower guns can work with ordinary air compressors normally, but drain water from the air storage tank regularly, as water vapor will corrode internal valve cores inside the gun. It is recommended to install an oil-water separator on the pipeline to output dry air stably, extend the service life of gun valves and avoid unstable air flow affecting dust removal performance.

Small and medium stores or scattered home renovation choose standard splicers with short in-stock delivery time, whose basic clamping and adjusting functions meet common tile and thin panel splicing needs. Large sintered stone factories and refined decoration projects with special requirements for panel thickness and splicing gaps can select custom splicers with adjustable clamp strokes and limit structures.

It fits mainstream large-size sintered stone slabs of 1200-3200mm. Control the single load quantity when handling ultra-thin panels, and avoid extreme load with a single lifter. The wear-resistant rubber anti-slip pads reduce risks of sliding and edge chipping. Two lifters are recommended for synchronous use when carrying extra long slabs for even force distribution.

Clean residual foam on the gun head right after use, and flush the internal valve with special cleaning fluid. If cured clogging occurs, do not poke violently; soak it in special solvent to soften cured foam for dredging. Empty residual material inside the gun before long-term storage, and apply lubricating grease to protect valves to reduce clogging risks.

Handheld glass cutters are compact, suitable for cutting scattered small glass pieces and edges in home decoration, easy to carry. Glass push cutters are equipped with fixed guide rails for straighter and more stable straight cuts, ideal for mass cutting of large full panels. Push cutters are preferred for large-scale engineering processing, and the two tools cannot replace each other.

Conventional vacuum suction cups fit flat and smooth panels, including clear glass, float glass, full-body tiles, polished tiles, standard sintered stone and artificial stone. Panels with concave-convex texture, holes, water seepage or thick dust will break the sealing effect and are not recommended. Rough matte stone can only be used for short-time operation with thickened sealing gaskets.